Installation Instructions
CE-607
The CE-607 regulator is designed for use on 2009-2011 FLH-FLT.
Remove Old Regulator
1) Remove the two-¼ 20 nuts
that hold the regulator on.
2) Remove the wire clamps and
save for reassembly.
3) Lift the regulator off the
mounting studs and tilt it forward to access the wire connections.
3) Remove the locking clips
and disconnect the stator and battery plugs.
Install New Regulator
.
1) Remove the retaining clips
from the stator and battery connectors on the new regulator. Save them for
reassembly.
3) Connect the stator and
battery plugs.
4) Install one plug-retaining
clip on each plug.
2) Place the regulator on the
mounting studs. Reuse the stock ¼’ nuts
to fasten the regulator to the frame.
5) Check the routing of all
wires to be sure they are not in a vulnerable position. Keep the wires away
from the motor monut. It moves with the motor and may wear through the
insulation . Be sure the wires are not in the very bottom of lower frame or
they will get pinched if you bottom out.
6) Start the motor and check
battery voltage. Battery voltage should run 14.4 to 14.6 volts.
Have A Good Ride!!
For complete product listing
and technical information see our web site.
REV. 4-11